Review of Geek Vape AEGIS Squonker kit

For years vapers have been arguing about what is better to use tank or drip, mech or board. It’s safe to say that such debates will be going on as long as vapers are alive. Many remember the moment when the first squonk mods appeared on the vape market, the attitude towards them was quite skeptical, but gradually they became more and more in demand and relevant. Manufacturers try to regularly release such devices, and try to make them as interesting as possible. Geek Vape also decided to make a mark in this segment, and released AEGIS Squonker kit, which will definitely interest many vapers. Naturally, looking at it, skeptics will say that it is Aegis Solo with a squonk system, and they will be partially right, as the manufacturer decided to refine and change the box mod, turning it into a squonk. The kit, in addition to the updated box mod, is equipped with the already well-known to vapers Tengu RDA drip, so the flavor and vape will be at the highest level.

General Information

Geek Vape AEGIS Squonker kit is a starter kit consisting of a new model of squonk-box AEGIS Squonker mod, which works on a single battery, is made in a protected case, and Tengu RDA, which allows you to get excellent flavor and bulk. There is not much to say about the drip, as it is already known to many vapers, and the reviews about Tengu RDA are only positive. The updated squonk box is made in a recognizable style, but with certain changes and additions. It still has IP67 protection, so the vaper should not be afraid of moisture, dust and falls from a small height. australian vape shop melbourne Buy Geek Vape AEGIS Squonker kit can be purchased in six colors black, gun metal, red, orange, blue and green.

Equipment

It should be said that the package of this starter kit will surprise even experienced vapers, but it is explained very simply in it are used a famous drip and no less famous mod. Therefore, in a rather large branded box vaper will find:

AEGIS Squonker mod;

A Tengu RDA drip atomizer with a pre-wound squonk pin;

Two pre-wound N80 Fused Clapton 4?

Organic cotton;

3mm;

Hexagon;

Screwdriver;

Regular pin;

Spare screws;

Spare orings;

Spare bottle;

Extra 810-free drip tip;

Adapter to use 510 drip tip;

Spare backplate;

USB cable for charging and firmware updates;

Warranty card;

User’s Manual.

Appearance and design

It’s worth saying at once that it’s not worth to dwell on the Tengu RDA review, as the drip is already known to many vapers and you can read about it in detail here. But the AEGIS Squonker is quite an interesting device, especially since Geek Vape had only two squonks GBOX and Athena in its range. The decision to add a squonker to the AEGIS lineup is quite logical, as this series is currently one of the most popular, especially since the lineup was recently updated with a new flagship.

Externally, AEGIS Squonker mod completely repeats the general stylistics of the series, but there are a few nuances that make it special. The overall dimensions of the device became slightly larger than Solo, but this is explained very simply due to the fact that the design provides a bottle, the developers had to slightly increase the size of the mod. Like previous versions, AEGIS Squonker mod has IP67 protection class, so it is not afraid of moisture, dust and small shocks.

The connector pad is large enough to allow the use of atomizers up to 28 mm in diameter, and it is made of steel, so you can not be afraid of scratching the top end of the device.

Considering that AEGIS Squonker mod is a squonk mod, the manufacturer has provided two main things – a decent sized bottle and a refill port. It is worth to stop a bit on the hole for refilling the liquid there is no need to remove the entire bottle, just slide a small slider on the top end of the device, which opens a medium-sized refill hole.

Quite an interesting solution is that the installation of the bottle is done by loosening a few hexagonal screws on the body. But that’s not all, as the kit comes with an additional back panel, which literally in a couple of minutes allows you to turn the squonker into a regular box mod.

AEGIS Squonker mod is powered by one traditional 18650 battery, which allows you to get a maximum power of 100 watts, which is installed from the end and fixed with a screw cap in order to ensure moisture protection of the battery. If needed, the battery can be charged using the standard micro-USB connector located on the side panel and closed with a silicone plug.

Board, functionality and features of use

It should be said at once that AEGIS Squonker mod is a slightly modified AEGIS Solo, so it uses the same AS-100 Chipset board, which is already familiar to many vapers. Using this board will allow vaper to use the device in standard modes – POWER, TC (NI200, SS, TI), TCR, BYPASS, VPC. The board, of course, raises the resistance from 0.05 ohms, which is nowadays almost a standard.

The device is equipped with a rather small display, on which the vaper will find all the necessary information about the level of battery charge, coil resistance, power, current, voltage and the number of puffs. Control and customization are traditional, simple and do not cause special questions.

Conclusions and impressions

It is impossible to say unequivocally that Geek Vape AEGIS Squonker kit is a good device, as one battery is unlikely to allow you to get good autonomy and high power, especially with the use of sub-ohm windings in the dripper. But at the same time, the device is quite versatile, allowing the vaper to get both a squonk and a box mod at the same time.

Advantages and disadvantages

Disadvantages

The power of the board is a bit exaggerated;

If you don’t grip it correctly, you can accidentally feed liquid into the drip tip.

Advantages

Recognizable design;

IP67 protection class;

Large liquid bottle;

Convenient refilling, for which you do not need to remove the bottle;

Possibility to replace the back panel;

The drip is very simple and easy to maintain;

Performance chipset;